Combination Meter: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.1 (See REMOVAL )
REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO.2 (See REMOVAL )
REMOVE INSTRUMENT PANEL FINISH PLATE (w/o Smart Key System)
1. Remove the instrument panel finish plate.
  
  Fig 1: Identifying Instrument Panel Finish Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
1. Using a moulding remover, disengage the 4 claws and 6 clips then remove the instrument panel sub-assembly.
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER

Fig 2: Identifying Instrument Panel Claws And Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Remove the 4 screws.
  
  Fig 3: Locating Instrument Cluster Finish Panel Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a moulding remover, disengage the 5 clips and remove the instrument cluster finish panel sub-assembly.
  
  Fig 4: Removing Instrument Cluster Finish Panel
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COMBINATION METER ASSEMBLY
1. Remove the 4 screws.
2. Pull out combination meter assembly, then disconnect the connectors.
  
  Fig 5: Locating Combination Meter Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002