How To Proceed With Troubleshooting

HINT:

• Use this procedure to troubleshoot the smart key system.
• Techstream can be used in steps  3,  4,  5 and  7.
• When troubleshooting the smart key system using Techstream with the engine switch off, connect Techstream to the vehicle and repeat turning any of the courtesy light switches on and off until communication between the tester and the vehicle begins (the interval ON and OFF should be less than 1.5 sec).

1. VEHICLE BROUGHT TO WORKSHOP 
2. CUSTOMER PROBLEM ANALYSIS 
   1. Confirm problem symptoms.
3. CHECK MULTIPLEX COMMUNICATION SYSTEM 
   1. Check for DTCs (See DTC CHECK / CLEAR ).

      HINT:

      This system uses multiplex communication. Check for DTCs for the multiplex communication system before performing the troubleshooting.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      DTC is not output.	A
      DTC is output.	B

   B:  Go to MULTIPLEX COMMUNICATION SYSTEM

   A: Go to next step 

4. CHECK DTC 
   1. Check for DTCs (See DTC CHECK / CLEAR  ).
      1. Record the DTCs.
   2. Clear the DTCs.

      HINT:

      After DTCs are all cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).

   3. Recheck for DTCs.
      1. Simulate the malfunction and check if the DTCs are output again.

         Result 

         RESULT REFERENCE
         
         

         Result	Proceed to
         DTC is output.	A
         DTC is not output.	B
         DTCs are not output, and the malfunction cannot be simulated or checked.	C

   B:  Go to step  10

   C : SYMPTOM SIMULATION 

   A: Go to next step 

5. DTC CHART 
6. CIRCUIT INSPECTION 
7. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. DATA LIST / ACTIVE TEST (See DATA LIST / ACTIVE TEST  )
   2. TERMINALS OF ECU (See TERMINALS OF ECU  )
   3. ON-VEHICLE INSPECTION (See ON-VEHICLE INSPECTION  )
8. ADJUST, REPAIR OR REPLACE 
9. CONFIRMATION TEST 

   NEXT : END 

10. PROBLEM SYMPTOMS TABLE 
11. ADJUST, REPAIR OR REPLACE 
12. CONFIRMATION TEST 

    NEXT : END