Inspection Procedure

1. Remove the outside handle.
   Fig 1: Identifying Door Oscillator Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the antenna and door oscillator connectors.
3. Measure the resistance between the oscillator and the antenna to check for an open circuit in the wire harness.

   Resistance: 

   Below 1 Ω 

4. Measure the resistance between the oscillator and the antenna to check for a short circuit in the wire harness.

   Resistance: 

   10 kΩ. or higher 

   HINT:

   Refer to the WIRING DIAGRAM  for connection of each terminal.

   Fig 2: Identifying Antenna Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE