LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Sequoia SR5, 4.7 T, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (2UZ-FE) - Component And System Testing, On-Vehicle Inspection, Removal, Inspection And Installation >> Knock Sensor >> Removal

Knock Sensor: Removal

  1. REMOVE INTAKE MANIFOLD ASSEMBLY 
    1. Remove the intake manifold (See REMOVAL ).
  2. REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY (See  REMOVAL  ) 
  3. REMOVE NO. 4 AIR INJECTION SYSTEM NOSE (See  REMOVAL  ) 
  4. REMOVE KNOCK SENSOR 
    1. Disconnect the 2 knock sensor connectors.
    2. Remove the 2 nuts and 2 knock sensors.
      Fig 1: Locating Knock Sensor Connectors And Nuts
      G05150462Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals