Service Data
2UZ-FE STARTING SERVICE DATA
| Starter assembly | Specified current: 100 A or less at 11.5V | ||
| Starter armature assembly | Standard resistance: Commutator (Segment - Segment): Below 1 Ω. Commutator - Armature core: 10 kΩ or higher |
||
| Standard diameter: 35.0 mm (1.38 in.) Minimum diameter: 34.0 mm (1.34 in.) Standard undercut depth: 0.7 mm (0.0276 in.) Minimum undercut depth: 0.2 mm (0.00787 in.) Maximum circle runout: 0.05 mm (0.00197 in.) |
|||
| Brush length | Standard brush length: 15.0 mm (0.591 in.) Minimum brush length: 9.0 mm (0.354 in.) |
||
| Starter brush holder assembly | Standard resistance: Positive brush holder - Negative brush holder: 10 kΩ or higher | ||
| Standard spring installed load: 21.5 to 27.5 N (2.2 to 2.8 kgf, 4.9 to 6.2 Ibf) Minimum spring installed load: 12.7 N (1.3 kgf, 2.9 Ibf) |
|||
| Starter yoke assembly | Standard resistance: Terminal C wire - Brushes: Below 1 Ω | ||
| Standard resistance: Terminal (A) - Terminal (B): 1.5 to 1.9 Ω | |||
| Magnet starter switch assembly | Standard resistance: Terminal 50 - Terminal C: Below 1 Ω | ||
| Standard resistance: Terminal 50 - Switch body: Below 2 Ω | |||
| Ignition or starter switch | LOCK | All terminals | 10 kΩ or higher |
| ACC | 2 (ACC)-4 (AM 1) | Below 1 Ω | |
| ON | 1 (IG1)-4(AM1) | ||
| 2 (ACC)-4 (AM 1) | |||
| 5 (AM2) - 6 (IG2) | |||
| START | 1 (IG1)-4(AM1) | ||
| 3(ST1)-4(AM1) | |||
| 5 (AM2) - 6 (IG2) | |||
| 5 (AM2) - 7 (ST2) | |||
| Starter relay | 3-5: 10 kΩ or higher (Battery voltage is not applied to terminals 1 and 2) 3-5: Below 1Ω (Battery voltage is applied to terminals 1 and 2) |
||
| ACC relay (Main body ECU) | DD47 - DD8: 10 kΩ or higher (Battery voltage is not applied to terminals DD45 and DD62) DD47 - DD8: Below 1Ω (Battery voltage is applied to terminals DD45 and DD62) |
||
| ACC cut relay | 3-4: Below 1Ω (Battery voltage is not applied to terminals 1 and 2) 3-4: 10 kΩ or higher (Battery voltage is applied to terminals 1 and 2) |
||