Inspection Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / (desired system) / Active Test.
5. According to the display on the Techstream, perform the Active Test.
   CAUTION: Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function does not operate.

   D-Door Motor 

   D-DOOR MOTOR REFERENCE CHART
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Power Window	Driver side power window	OFF/UP/DOWN	-

   P-Door Motor 

   P-DOOR MOTOR REFERENCE CHART
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Power Window	Front passenger side power window	OFF/UP/DOWN	-

   OK: Each power window motor operates. 

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   OK	A
   NG (Driver side power window)	B
   NG (Front passenger side power window)	C

B: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL  )

C: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL  )

A: Go to next step 

1. Initialize the power window regulator motor (See INITIALIZATION  ).
2. Check that each power window operates normally by opening and closing the window (See OPERATION CHECK  ).

   OK: Each power window operates normally. 

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   OK	A
   NG (Driver side power window)	B
   NG (Front passenger side power window)	C

B: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL  )

C: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL  )

A: Go to next step 

1. Check that the power window components are installed correctly.

   OK: Power window components are installed correctly. 

   HINT:

   When the power window components are installed correctly, the problem has been caused by battery disconnection while the ignition switch is ON or the motor being overheated.

NG: INSTALL PARTS CORRECTLY 

OK: END