Inspection Procedure
NOTE:
When replacing the VSC actuator assembly, perform zero point calibration (See CALIBRATION
).
- DISCONNECT BATTERY NEGATIVE TERMINAL
- Disconnect the cable from the negative (-) battery terminal to clear the steering angle sensor zero point.
- PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION
- Drive the vehicle straight ahead at 15 km/h (9 mph) or more for a few seconds (zero point is obtained automatically).
- RECONFIRM DTC
- Clear the DTC(s) (See DTC CHECK/CLEAR ).
- Turn the ignition switch to ON.
- Check if the same DTC is recorded (See DTC CHECK/CLEAR
).
Result
RESULT REFERENCEResult Proceed to DTC is output A DTC is not output B
B: CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (See HOW TO PROCEED WITH TROUBLESHOOTING )
A: Go to Next Step
- REPLACE STEERING ANGLE SENSOR
- Replace the steering angle sensor (See INSPECTION ).
- RECONFIRM DTC
- Clear the DTC (See DTC CHECK/CLEAR ).
- Check if the same DTC is recorded (See DTC CHECK/CLEAR
).
Result
RESULT REFERENCEResult Proceed to DTC is output A DTC is not output B
B: END
A: REPLACE VSC ACTUATOR ASSEMBLY (See REMOVAL )