Inspection Procedure
NOTE:
When replacing the VSC actuator assembly, perform zero point calibration (See CALIBRATION
).
- PERFORM TEST MODE INSPECTION
- Perform a TEST MODE inspection (See TEST MODE PROCEDURE ).
- RECONFIRM DTC
- Clear the DTC (See DTC CHECK/CLEAR ).
- Start the engine.
- Check if the same DTC is output (See DTC CHECK/CLEAR
).
Result
RESULT REFERENCEResult Proceed to DTC is output A DTC is not output B
B: CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (See HOW TO PROCEED WITH TROUBLESHOOTING )
A: REPLACE VSC ACTUATOR ASSEMBLY (See REMOVAL )