Inspection Procedure

1. Turn the window lock switch OFF and operate the switches on the power window regulator master switch. Check that the remote UP/DOWN function operates normally.

   OK: Remote UP/DOWN function operates normally. 

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   OK	A
   NG (Front RH side)	B
   NG (Rear side)	C

   Fig 1: Identifying Window Lock Switch

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

B: Go to step 2 

C: REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY  (See REMOVAL  )

A: END 

1. Check for LIN communication system DTCs related to the power window control system (See DIAGNOSTIC TROUBLE CODE CHART ).

   OK: LIN communication system DTCs are not output. 

NG: GO TO LIN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Master Switch / Data List /
5. According to the display on the Techstream, read the Data List.

   Master Switch 

   MASTER SWITCH REFERENCE CHART
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   P Door P/W Auto SW	Front passenger side power window remote auto UP/DOWN switch signal / ON or OFF	ON: Front passenger side power window remote auto UP/DOWN switch on multiplex network master switch operated OFF: Front passenger side power window switch on multiplex network master switch not operated	-
   P Door P/W Up SW	Front passenger side power window remote manual UP switch signal / ON or OFF	ON: Front passenger side power window remote manual UP switch on multiplex network master switch operated OFF: Front passenger side power window switch on multiplex network master switch not operated	-
   P Door P/W Down SW	Front passenger side power window remote manual DOWN switch signal / ON or OFF	ON: Front passenger side power window remote manual DOWN switch on multiplex network master switch operated OFF: Front passenger side power window switch on the multiplex network master switch not operated	-

   OK: The Techstream display changes normally when master switch is operated. 

NG: REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY  (See REMOVAL  )

OK: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH  (See REMOVAL  )