Inspection Procedure

1. Check for DTCs (See DTC CHECK / CLEAR  )

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   DTC is not output	A
   B2311 is output	B
   B2312 is output	C
   B2313 is output	D
   LIN communication system DTCs are output	E

B: GO TO DTC (B2311)  (See DTC B2311 POWER WINDOW MOTOR MALFUNCTION  )

C: GO TO DTC (B2312)  (See DTC B2312 POWER WINDOW SWITCH MALFUNCTION  )

D: GO TO DTC (B2313)  (See DTC B2313 GLASS POSITION INITIALIZATION INCOMPLETE  )

E: GO TO LIN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

A: Go to next step 

1. Check that the manual UP/DOWN function using the multiplex network master switch can operate the driver side power window (See OPERATION CHECK  )

   OK: Manual UP/DOWN function operates normally. 

NG: GO TO OTHER FLOW CHART (DRIVER SIDE POWER WINDOW MOTOR CIRCUIT)  (See DRIVER SIDE POWER WINDOW DOES NOT OPERATE WITH POWER WINDOW MASTER SWITCH  )

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Master Switch / Data List.
5. According to the display on the Techstream, read the Data List.

   Master Switch 

   MASTER SWITCH REFERENCE CHART
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D Door P/W Auto SW	Driver side power window auto UP/ DOWN switch signal / ON or OFF	ON: Driver side power window auto UP/ DOWN switch operated OFF: Driver side power window switch not operated	-

   OK: The Techstream display changes normally when master switch is operated. 

NG: REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY  (See REMOVAL  )

OK: REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH  (See REMOVAL  )