Inspection Procedure

1. Initialize the power window regulator motor (See INITIALIZATION  ).
2. Check if the power window AUTO UP/DOWN function operates (See OPERATION CHECK  ).

   OK: AUTO UP/DOWN function operates. 

NG: Go to step 2 

OK: END (PROBLEM DUE TO INITIALIZATION FAILURE) 

1. Remove the installation bolt of the door glass and hold the glass by hand. When raising the glass by hand, check that the glass moves smoothly.
   NOTE:

   • Make sure that the door glass fits to the glass run properly.
   • Make sure that the glass run is not deformed, and does not have foreign matter.

   OK: Door glass moves smoothly. 

NG: INSTALL DOOR GLASS AND/OR GLASS RUN PROPERLY 

OK: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (APPLICABLE LOCATION)  (See REMOVAL  )