LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> RAV4 Base, 2.4 D, AWD >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Case -GF1A- RAV4 >> 4WD Control Ecu >> Removal

4WD Control Ecu: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY  (See REMOVAL )
  3. REMOVE 4WD CONTROL ECU 
    1. Disconnect the connector.
    2. Remove the bolt and ECU.
      Fig 1: Locating 4WD Control ECU Bolt
      G05584740Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals