Rear Axle Hub And Bearing: Installation

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH 
   1. Install the axle hub and bearing LH on the axle beam with the 4 bolts.

      Torque: 61 N*m (622 kgf*cm, 45 ft.*lbf) 

2. CONNECT SKID CONTROL SENSOR CONNECTOR 
3. INSPECT REAR AXLE HUB BEARING LOOSENESS (See  ON-VEHICLE INSPECTION  ) 
4. INSPECT REAR AXLE HUB BEARING RUNOUT (See  ON-VEHICLE INSPECTION  ) 
5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY 
6. INSTALL REAR WHEEL 

   Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

7. INSPECT REAR WHEEL ALIGNMENT (See  INSPECTION  ) 
8. CHECK ABS SPEED SENSOR SIGNAL