Park / Neutral Position Switch: Installation

INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Install the park/neutral position switch to the manual valve shaft.
2. Temporarily install the 2 bolts.
3. Place a new lock plate and tighten the nut.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
4. Temporarily install the control shaft lever.
5. Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
6. Remove the control shaft lever.
7. Align the groove with the neutral basic line.
8. Hold the switch in position and tighten the 2 bolts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  Fig 3: Identifying Park/Neutral Position Switch Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. Using a screwdriver, stake the nut with the lock plate.
  
  Fig 4: Identifying Staking Nut With Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Install the control shaft lever, washer and nut.
  Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
  
  Fig 5: Identifying Control Shaft Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
11. Connect the park/neutral position switch connector.
INSTALL TRANSMISSION CONTROL ASSEMBLY
1. Temporarily install the control cable to the control shaft lever with the nut.
2. Install the control cable with the clip to the bracket.
  NOTE: Insert the cable securely.
INSTALL BATTERY CARRIER
1. Install the battery carrier with the 4 bolts.
  Torque: 13 N*m (132 kgf*cm, 10 ft.*lbf)
INSTALL BATTERY
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSPECT SHIFT LEVER POSITION (See ADJUSTMENT )
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (See ADJUSTMENT )