Vane Pump: Installation

1. Install the vane pump assembly with the 2 bolts and nuts.

   Torque: 37 N*m (380 kgf*cm, 27 ft.*lbf) 

2. Connect the oil pressure switch connector.
   NOTE: Be careful that the oil does not adhere to the connector.
   Fig 1: Installing Vane Pump Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, connect the pressure feed tube assembly.

   SST 09023-38401 

   Torque: 41 N*m (420 kgf*cm, 30 ft.*lbf) 

   HINT:

   • Use a torque wrench with a fulcrum length of 345 mm (13.58 in.).
   • This torque value is effective when SST is parallel to a torque wrench.
2. Connect the pressure feed tube clamp with the bolt.

   Torque: 7.8 N*m (80 kgf*cm, 69 ft.*lbf) 

   Fig 2: Installing Pressure Feed Tube Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the oil reservoir to pump hose No. 1 with the clip.

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)