Vane Pump: Disassembly

REMOVE VANE PUMP BRACKET REAR
1. Remove the bolt and vane pump bracket rear.
  
  Fig 1: Locating Vane Pump Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FIX VANE PUMP ASSEMBLY
1. Using SST, hold the vane pump assembly in a vise.
  SST 09630-00014 (09631-00132)
REMOVE POWER STEERING SUCTION PORT UNION
1. Remove the bolt and power steering suction port union.
2. Remove the O-ring from the power steering suction port union.
REMOVE FLOW CONTROL VALVE
1. Remove the pressure port union.
2. Remove the O-ring from the pressure port union.
3. Remove the flow control valve and flow control valve compression spring.
  
  Fig 2: Fixing Vane Pump Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE POWER STEERING OIL PRESSURE SWITCH
NOTE: Be careful so that oil pressure switch is not dropped or strongly damaged, however if it is damaged replace it with a new one.
REMOVE VANE PUMP HOUSING REAR
1. Remove the 4 bolts and vane pump housing rear from the vane pump housing front.
2. Remove the O-ring from the vane pump housing front.
REMOVE WITH PULLEY SHAFT SUB-ASSEMBLY
1. Using a screwdriver, remove the snap ring from the w/pulley shaft sub-assembly.
2. Remove the w/pulley shaft sub-assembly.
REMOVE VANE PUMP ROTOR
1. Remove the 10 vane plates.
2. Remove the vane pump rotor.
REMOVE VANE PUMP CAM RING
REMOVE VANE PUMP SIDE PLATE FRONT
1. Remove the side plate from the pump housing front.
2. Remove the O-ring from the side plate front.
  
  Fig 3: Identifying Vane Pump Side Plate Front
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the O-ring from the pump housing front.
  
  Fig 4: Locating O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE VANE PUMP HOUSING OIL SEAL
1. Using SST and a hammer, remove the vane pump housing oil seal.
  SST 09631-10030
  
  NOTE: Be careful not to damage the pump housing.
  
  Fig 5: Removing Vane Pump Housing Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002