Data List/Active Test

1. READ DATA LIST 

   HINT:

   Using the Techstream to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

   NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
   1. Connect the Techstream to the DLC3.
   2. Turn the engine switch on (IG).
   3. Turn the Techstream on.
   4. Enter the following menus: Body Electrical/(desired system)/Data List.
   5. According to the display on the Techstream, read the Data List.

      Combination Meter 

      COMBINATION METER SPECIFICATIONS
      
      

      Tester Display	Measurement Item/Range	Normal Condition
      Driver Side Seatbelt Warning Buzzer	Driver side seat belt warning signal/ON or OFF	Current customize setting displayed ON: Active OFF: Not active
      P - Seatbelt Warning Buzzer	Front passenger side seat belt warning signal/ON or OFF	Current customize setting displayed ON: Active OFF: Not active

      SRS Airbag 

      SRS AIRBAG SPECIFICATIONS
      
      

      Tester Display	Measurement Item/Range	Normal Condition
      Left side Buckle SW	Driver side seat belt/set or unset	Set: Driver side seat belt is fastened Unset: Driver side seat belt is unfastened
      Right side Buckle SW	Front passenger side seat belt/set or unset	Set: Front passenger side seat belt is fastened Unset: Front passenger side seat belt is unfastened

2. PERFORM ACTIVE TEST 

   HINT:

   Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

   1. Connect the Techstream to the DLC3.
   2. Turn the engine switch on (IG).
   3. Turn the Techstream on.
   4. Enter the following menus: Body Electrical/Combination Meter/Active Test.
   5. According to display on the Techstream, perform the Active Test.

Combination Meter