Front Door Lock: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH  (See REASSEMBLY )
2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH  (See REASSEMBLY )
3. INSTALL FRONT DOOR LOCK ASSEMBLY LH 
   1. Apply MP grease to the sliding parts of the front door lock assembly.
   2. Insert the front door lock open rod to the front door lock assembly.
   3. Make sure that the front door lock open rod is securely connected to the front door lock assembly.
   4. Using a T30 "TORX" wrench, install the door lock with the 3 screws.

      Torque: 5.0 N.m (51 kgf*cm, 44 in.*lbf) 

      Fig 1: Identifying Front Door Lock Assembly LH Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH  (See REASSEMBLY )
5. INSTALL FRONT DOOR REAR LOWER FRAME SUBASSEMBLY LH  (See REASSEMBLY )
6. INSTALL FRONT NO. 2 DOOR STIFFENER CUSHION  (See REASSEMBLY )
7. INSTALL FRONT DOOR SERVICE HOLE COVER LH  (See REASSEMBLY )
8. INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY LH  (See REASSEMBLY )
9. INSTALL COURTESY LIGHT ASSEMBLY  (See INSTALLATION )
10. INSTALL DOOR ASSIST GRIP COVER LH  (See REASSEMBLY )
11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH  (See REASSEMBLY )
12. INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH  (See REASSEMBLY )
13. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH  (See REASSEMBLY )
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
15. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (See DIAGNOSIS SYSTEM ).