Terminals Of Ecu

CHECK REAR TELEVISION CAMERA ASSEMBLY

Fig 1: Identifying S5 Camera Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the voltage and resistance according to the value(s) in the table below.

VOLTAGE AND RESISTANCE SPECIFICATION

Terminal No. (Symbols)	Wiring Color	Terminal Description	Condition	Specified Condition
S5-3 (CGND) - Body ground	W - Body ground	Ground	Always	Below 1 Ω
S5-4 (CB+) - S5-3 (CGND)	B-W	Power source	Engine switch on (IG), shift lever moved to R	5.8 to 6.5 V

If the result is not as specified, there may be a malfunction on the wire harness side.

Measure the waveform according to the value(s) in the table below.

TERMINAL DESCRIPTION AND SPECIFIED CONDITION

Terminal No. (Symbols)	Wiring Color	Terminal Description	Condition	Specified Condition
S5-2 (CV+) - S5-1 (CV-)	R - Shielded	Display signal	Engine switch on (IG), shift lever moved to R	Waveform 1

If the result is not as specified, the camera may have a malfunction.

Using an oscilloscope, check waveform 1.

Waveform 1 (Reference)

WAVEFORM 1 REFERENCE

Item	Content
Terminal No. (Symbols)	S5-2 (CV+) - S5-1 (CV-)
Tool Setting	0.2 V/DIV., 0.2 μs/DIV.
Condition	Engine switch on (IG), shift lever moved to R

CHECK MULTI-DISPLAY (See TERMINALS OF ECU )

Fig 2: Identifying Oscilloscope Waveform 1
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002