2GR-FE Engine Mechanical: Equipment
EQUIPMENT TABLE
| Abrasive compound |
| Brush |
| Caliper gauge |
| Carbide cutter (30°) |
| Carbide cutter (45°) |
| Carbide cutter (60°) |
| Carbide cutter (75°) |
| Connecting rod aligner |
| Cylinder gauge |
| Dial indicator |
| Dye penetrant |
| Engine tune-up tester |
| Groove cleaning tool |
| Heater |
| Micrometer |
| Piston ring compressor |
| Piston ring expander |
| Plastigage |
| Precision straight edge |
| Press |
| Reamer (5.5 mm) |
| Ridge reamer |
| Soft brush |
| Solvent |
| Spring tester |
| Steel square |
| Thermometer |
| Torque wrench |
| Torx socket wrench |
| Valve seat cutter |
| Valve guide bushing brush |
| V-block |
| Vernier calipers |
| Wire brush |
| Bar |
| Chain Block |
| CO/HC meter |
| Compression gauge |
| Dial indicator with magnetic base |
| Engine Sling Device |
| Feeler gauge |
| Radiator cap tester |
| Slide calipers |
| Tachometer |
| Timing light |
| Wooden block |
| Deep socket wrench |
| Screwdriver |
| Hammer |
| Needle-noise plier |
| Compressed air |
| Magnetic finger |
| Plastic hammer |
| Gasket scraper |
| Piston |
| Nipper |
HINT:
Torx is registered trademark of Textron Inc.