LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Corolla LE, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Rear Axle Beam >> Reassembly

Rear Axle Beam: Reassembly

  1. INSTALL REAR AXLE CARRIER BUSH LH 
    1. Align the matchmarks on the rear axle beam assembly with the 2 notches of a new bushing and temporarily install the bushing to the rear axle beam assembly.
    2. Using SST, install the bushing to the axle beam.

      SST 09950-40011 (09951-04020, 09952-04010, 09953-04030, 09954-04020, 09955-04051, 09957-04010, 09958-04011), 09950-60010 (09951-00620), 09710-04101 

      NOTE:
      • Hang the claw of SST to the bushing deeply and firmly.
      • Do not scratch the rubber portion of the bushing.
      • Do not deform the bushing rib.
      Fig 1: Installing Bushing To Axle Beam Using SST
      G05194699Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL REAR AXLE CARRIER BUSH RH 
    1. Install the RH side by the same procedures with the LH side.
scientia non olet · About LEMON Manuals