Section 68 (Air Conditioning): Condenser: Installation

WARNING: This page is about a different car, the 2008 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL COOLER CONDENSER BRACKET NO.2
1. Install the cooler condenser bracket No.2 with the bolt.
  Torque: 4.4 N*m (45 kgf*cm, 39 in.*lbf)
  
  Fig 1: Identifying Cooler Condenser Bracket No.2 With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COOLER CONDENSER BRACKET NO.1
1. Install the cooler condenser bracket No.1 with the bolt.
  Torque: 4.4 N*m (45 kgf*cm, 39 in.*lbf)
  
  Fig 2: Identifying Cooler Condenser Bracket No.1 With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COOLER CONDENSER ASSEMBLY
1. Install the cooler condenser assembly with the 2 nuts.
  Torque: 9.8 N*m (100 kgf*cm, 85 in.*lbf)
  
  HINT:
  
  If the condenser is replaced with a new one, add compressor oil to the new condenser.
  
  Capacity:
  
  40 cc (1.4 fl.oz.)
  
  Compressor oil:
  
  ND-8 or equivalent
  
  Fig 3: Identifying Cooler Condenser Assembly With Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL RADIATOR SUPPORT UPPER
HINT:
- 2AZ-FE (See INSTALLATION )
- 3MZ-FE (See INSTALLATION )
INSTALL COOLER REFRIGERANT LIQUID PIPE A
1. Remove the attached vinyl tape from the tube and connecting part of the cooler condenser assembly.
2. Sufficiently apply compressor oil to a new O-ring and pipe joint.
  Compressor oil:
  
  ND-OIL 8 or equivalent
3. Install the O-ring to the cooler refrigerant liquid pipe A.
4. Connect the cooler refrigerant liquid pipe A to the cooler condenser assembly with the bolt.
  Torque: 5.4 N*m (55 kgf*cm, 47 in.*lbf)
INSTALL COOLER REFRIGERANT DISCHARGE HOSE NO.1
1. Remove the attached vinyl tape from the tube and connecting part of the cooler condenser assembly.
2. Sufficiently apply compressor oil-to a new O-ring and hose joint.
  Compressor oil:
  
  ND-OIL 8 or equivalent
3. Install the O-ring to the cooler refrigerant discharge hose No. 1.
  
  Fig 4: Identifying Cooler Refrigerant Liquid Pipe To Cooler Condenser Assembly With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the cooler refrigerant discharge hose No.1 to the cooler condenser assembly with the bolt.
  
  Fig 5: Identifying Cooler Refrigerant Discharge Hose No.1 And Cooler Condenser Assembly With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 5.4 N*m (55 kgf*cm, 47 in.*lbf)
CHARGE REFRIGERANT (See REPLACEMENT )
WARM UP ENGINE (See REPLACEMENT )
INSPECT FOR REFRIGERANT LEAK (See REPLACEMENT )