Check Mode Procedure

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

CHECK MODE (SIGNAL CHECK): DTC CHECK
1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch to the ON position.
3. Select the "SIGNAL CHECK", and proceed checking with the intelligent tester.
  NOTE: Select the "SIGNAL CHECK" from the "DTC CHECK" screen displayed on the intelligent tester to clear the output DTCs (both present and past).
  
  Fig 1: Connecting Intelligent Tester To DLC3
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  - DTCs can be detected more sensitivity in check mode than in normal diagnosis mode.
  - Perform check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.