Rear Strut Rod: Installation

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY
1. Install the strut rod (rear side), bolt and nut, and temporarily tighten the bolt.
  NOTE: When installing the bolt, fix the nut and temporarily tighten the bolt.
  
  HINT:
  
  Insert the bolt from the inner side of the vehicle and temporarily install the bolt.
  
  Fig 1: Locating Strut Rod Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the strut rod (front side) with the bolt and nut.
  NOTE: When installing the bolt, fix the nut and temporarily tighten the bolt.
  
  Fig 2: Locating Strut Rod (Front Side) With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
STABILIZE SUSPENSION
1. Jack up the rear axle carrier, placing a wood block to avoid damage. Apply load to the suspension so that the installed bolt of the suspension arm assembly No. 1 (inner side of the vehicle) is horizontally aligned with the center of the rear axle hub.
  
  Fig 3: Jacking Up Rear Axle Carrier
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FULLY TIGHTEN REAR STRUT ROD ASSEMBLY
1. Fully tighten the bolt.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 4: Locating Strut Rod Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fully tighten the bolt.
  Torque: 113 N*m (1,150 kgf*cm, 83 ft.*lbf)
  
  Fig 5: Locating Strut Rod (Front Side) With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the parking brake cable with the bolt.
  Torque: 5.4 N*m (55 kgf*cm, 48 ft.*lbf)
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
INSPECT REAR WHEEL ALIGNMENT
HINT:

See REAR WHEEL ALIGNMENT

Fig 6: Locating Parking Brake Cable With Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002