LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Corolla LE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Suspension System) >> Front Stabilizer Bar >> Installation

Front Stabilizer Bar: Installation

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STABILIZER BAR FRONT 
    1. install the stabilizer bar front to the vehicle.
  2. INSTALL FRONT STABILIZER BAR BUSH NO.1 
    1. Install the bush to the outer side of the each bush stopper on stabilizer bar.
    2. Place the cutout of the stabilizer bush facing the rear side as shown in the illustration.
      Fig 1: Identifying Front Stabilizer Bar Bush
      G05130709Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL RACK & PINION POWER STEERING GEAR ASSEMBLY (See  INSTALLATION  ) 
  4. INSTALL PRESSURE FEED TUBE ASSEMBLY (See  INSTALLATION  ) 
  5. INSTALL STEERING GEAR OUTLET RETURN TUBE (See  INSTALLATION  ) 
  6. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY (See  INSTALLATION  ) 
  7. INSTALL TIE ROD ASSEMBLY LH (See See  INSTALLATION  ) 
  8. INSTALL TIE ROD ASSEMBLY RH 

    HINT:

    Install the RH side following the same procedure as the LH side.

  9. INSTALL FRONT STABILIZER BRACKET NO.1 LH 
    1. Install the front stabilizer bracket No. 1 LH with the 2 bolts.

      Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf) 

    Fig 2: Locating Front Stabilizer Brackets No. 1 LH With Bolts
    G05130707Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. INSTALL FRONT STABILIZER BRACKET NO.1 RH 

    HINT:

    Install the RH side following the same procedure as the LH side.

  11. INSTALL FRONT STABILIZER LINK ASSEMBLY LH 
    1. Install the front stabilizer link assembly LH with the 2 nuts.

      Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf) 

      HINT:

      Use a hexagon wrench (6 mm) to hold the stud if the ball joint turns together with the nut.

    Fig 3: Locating Front Stabilizer Link Assembly LH With Nuts
    G05001265Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. INSTALL FRONT STABILIZER LINK ASSEMBLY RH 

    HINT:

    Install the RH side following the same procedure as the LH side.

  13. INSTALL FRONT WHEEL 

    Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

  14. BLEED POWER STEERING FLUID 

    HINT:

    See ON-VEHICLE INSPECTION

  15. INSPECT FOR POWER STEERING FLUID LEAK 
  16. INSPECT AND ADJUST STEERING WHEEL CENTER POINT 
  17. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT 

    HINT:

    See FRONT WHEEL ALIGNMENT 

scientia non olet · About LEMON Manuals