Section 113 (Engine Control System (2AZ-FE)): ECM: Removal

WARNING: This page is about a different car, the 2008 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
REMOVE FRONT DOOR SCUFF PLATE RH
HINT:

See REMOVAL .
REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
HINT:

See REMOVAL .
REMOVE INSTRUMENT PANEL NO.1 UNDER COVER SUB-ASSEMBLY
HINT:

See REMOVAL .
REMOVE INSTRUMENT PANEL FINISH LOWER PANEL RH
HINT:

See REMOVAL .
REMOVE ECM
1. Remove the 2 wire harness clamps.
2. Disconnect the 5 ECM connectors.
3. Remove the 2 nuts and ECM.
  
  Fig 1: Identifying ECM Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ECM BRACKET
1. Remove the 2 screws and ECM bracket.
  
  Fig 2: Identifying ECM Bracket Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ECM BRACKET NO.2
1. Remove the 2 screws and ECM bracket.
  
  Fig 3: Identifying ECM Bracket No 2 Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002