Rear Axle Hub: Installation

INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
1. Install the hub & bearing assembly LH with the 4 bolts.
  Torque: 61 N*m (622 kgf*cm, 45 ft.*lbf)
  
  Fig 1: Locating Hub And Bearing Assembly LH Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT SKID CONTROL SENSOR WIRE (w/ ABS)
NOTE: Do not twist the sensor wire when connecting it.
INSPECT REAR AXLE HUB BEARING LOOSENESS (see REAR AXLE HUB )
INSPECT REAR AXLE HUB RUNOUT (see REAR AXLE HUB )
INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CHECK ABS SPEED SENSOR SIGNAL (w/ ABS)
1. Vehicle Stability Control System (See TEST MODE PROCEDURE )
2. Anti-lock Brake System (See TEST MODE PROCEDURE )