Steering Pad Switch: Installation

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING PAD SWITCH ASSEMBLY
1. Engage the 2 pins and install the steering pad switch assembly.
2. Install the screw and engage the clamp.
  Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  
  Fig 1: Locating Steering Pad Switch Pin
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Engage the 2 pins and install the steering pad switch assembly.
  
  Fig 2: Identifying Steering Pad Switch Pin And Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the screw and engage the clamp.
  Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
5. Connect the connector to the spiral cable.
INSTALL STEERING PAD (See INSTALLATION )
INSTALL NO. 3 LOWER STEERING WHEEL COVER (See INSTALLATION )
INSTALL NO. 2 LOWER STEERING WHEEL COVER (See DISPOSAL )
CONNECT BATTERY NEGATIVE TERMINAL
HINT:

See AIRBAG SYSTEM
PERFORM INITIALIZATION
HINT:

See INITIALIZATION
INSPECT STEERING PAD (See DISPOSAL )
INSPECT SRS WARNING LIGHT
HINT:

See DIAGNOSIS SYSTEM