Throttle Body: Installation

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL THROTTLE BODY ASSEMBLY
1. Install a new gasket on the intake manifold, as shown in the illustration.
  
  Fig 1: Identifying Gasket On Intake Manifold
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the throttle body and fuel pipe support with the 4 bolts.
  Torque: 30 N*m (305 kgf*cm, 22 ft.*lbf)
3. Connect the 2 water bypass hoses to the throttle body.
4. Connect the throttle control motor & throttle position sensor connector.
5. Connect the vacuum hose to the throttle body.
  
  Fig 2: Locating Throttle Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
ADD ENGINE COOLANT
HINT:

See COOLANT
CHECK FOR ENGINE COOLANT LEAKS
HINT:

See REPLACEMENT