Section 16 (Engine Control System (2AZ-FE)): ECM: Removal

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT BATTERY NEGATIVE TERMINAL
REMOVE FRONT DOOR SCUFF PLATE RH
HINT:

See REMOVAL (Coupe) or REMOVAL (Convertible).
REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
HINT:

See REMOVAL (Coupe) or REMOVAL (Convertible).
REMOVE INSTRUMENT PANEL NO.1 UNDER COVER SUB-ASSEMBLY
HINT:

See REMOVAL
REMOVE INSTRUMENT PANEL FINISH LOWER PANEL RH
HINT:

See REMOVAL
REMOVE ECM
1. Remove the 2 wire harness clamps.
2. Disconnect the 5 ECM connectors.
3. Remove the 2 nuts and ECM.
  
  Fig 1: Locating ECM Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ECM BRACKET
1. Remove the 2 screws and ECM bracket.
  
  Fig 2: Locating ECM Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ECM BRACKET NO.2
1. Remove the 2 screws and ECM bracket.
  
  Fig 3: Locating ECM Bracket No.2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002