Crankshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See SPECIFIED TORQUE FOR STANDARD BOLTS ).

REMOVE ENGINE UNDER COVER RH
1. Remove the 5 screws, 3 clips and under cover.
  
  Fig 1: Locating Engine Under Cover RH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT FENDER APRON SEAL RH
1. Remove the clip, 2 bolts and apron seal.
  
  Fig 2: Locating Clip, Bolts And Apron Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CRANKSHAFT POSITION SENSOR
1. Disconnect the sensor connector.
  
  Fig 3: Locating Crankshaft Position Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the bolt, clamp and sensor.