Front Stabilizer Bar: Installation

INSTALL FRONT NO. 1 STABILIZER BAR BUSHING
1. Install the 2 front stabilizer bar bushings No. 1 to the outside of the bushing stopper on the front stabilizer bar.
NOTE: Make sure that the cutout of the front stabilizer bar bushing No. 1 faces the rear side as shown in the illustration.
INSTALL FRONT NO. 1 STABILIZER BRACKET LH
1. Install the front No. 1 stabilizer bracket LH.
INSTALL FRONT NO. 1 STABILIZER BRACKET RH
1. Install the front No. 1 stabilizer bracket RH.
Fig 1: Identifying Front Stabilizer Bar Bushings No. 1 To Outside
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT STABILIZER BAR
1. Install the front stabilizer bar with the 2 bolts. (LH Side)
  Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf)
  
  Fig 2: Locating Front Stabilizer Bar With Bolts (LH Side)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the front stabilizer bar with the 2 bolts. (RH Side)
  Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf)
  
  Fig 3: Locating Front Stabilizer Bar With Bolts (RH Side)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
HINT:

Refer to the instructions for installation of the engine assembly (See INSTALLATION for 2AZ-FE, INSTALLATION for 2GR-FE)
INSTALL FRONT STABILIZER LINK ASSEMBLY LH
1. Install the front stabilizer link assembly LH with the 2 nuts.
  Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf)
  
  HINT:
  
  If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
  
  Fig 4: Locating Front Stabilizer Link Assembly LH With Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT STABILIZER LINK ASSEMBLY RH
1. Install the front stabilizer link assembly RH with the 2 nuts.
  Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf)
  
  HINT:
  
  If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
  
  Fig 5: Locating Front Stabilizer Link Assembly RH With Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TIE ROD END SUB-ASSEMBLY (See INSTALLATION )
CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY (See INSTALLATION )
PLACE FRONT WHEELS FACING STRAIGHT
INSTALL FRONT WHEELS
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(See ADJUSTMENT )