LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry CE, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Brake Control - Hybrid) >> Steering Angle Sensor >> Installation

Steering Angle Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL STEERING ANGLE SENSOR 
    1. Align the locating pins, engage the claws, and install the steering angle sensor to the spiral cable.
      2. Fig 1: Identifying Steering Angle Sensor And Locating Pins
      G05011306Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSOR  (See INSTALLATION )
  3. INSTALL STEERING COLUMN COVER  (See INSTALLATION )
  4. ADJUST SPIRAL CABLE  (See INSTALLATION )
  5. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  6. INSPECT STEERING WHEEL CENTER POINT 
  7. INSTALL STEERING PAD  (See INSTALLATION )
  8. INSTALL NO. 2 LOWER STEERING WHEEL COVER  (See INSTALLATION )
  9. INSTALL NO. 3 LOWER STEERING WHEEL COVER  (See INSTALLATION )
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  11. INSPECT STEERING PAD  (See INSTALLATION )
  12. INSPECT SRS WARNING LIGHT  (See INSTALLATION )
  13. PERFORM INITIALIZATION 
    NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal. (See INITIALIZATION )
scientia non olet · About LEMON Manuals