LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry CE, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Brake Control - Hybrid) >> Front Speed Sensor >> Inspection

Front Speed Sensor: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT FRONT SPEED SENSOR 
    1. Inspect the front speed sensor. If any of the following occurs, replace the front speed sensor with a new one:
      • The surface of the front speed sensor is cracked, dented, or chipped off.
      • The connector or wire harness is scratched, cracked, or damaged.
      • The front speed sensor has been dropped.
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance LH 

      RESISTANCE REFERENCE

      Tester Connection Condition Specified Condition
      1 (FL+) - 2 (FL-) Always 1.4 to 1.8 kΩ or at 20°C (68°F)
      1 (FL+) - Body ground Always 10 kΩ or higher
      2 (FL-) - Body ground Always 10 kΩ or higher
      Fig 1: View Of Front Speed Sensor Resistance
      G04978023Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      RH 

      RESISTANCE REFERENCE

      Tester Connection Condition Specified Condition
      1 (FR+) - 2 (FR-) Always 1.4 to 1.8 kΩ or at 20°C (68°F)
      1 (FR+) - Body ground Always 10 kΩ or higher
      2 (FR-) - Body ground Always 10 kΩ or higher

      If the value is not as specified, replace the front speed sensor.

scientia non olet · About LEMON Manuals