Rear Wheel Alignment: Adjustment

INSPECT TIRE
1. Inspect the tire (See INSPECTION ).
MEASURE VEHICLE HEIGHT
1. Measure the Vehicle height (See ADJUSTMENT ).
  NOTE: Before inspecting wheel alignment, adjust the vehicle height to the specified value.

INSPECT TOE-IN

Inspect the toe-in.

Toe-in

TOE-IN SPECIFICATION

Toe-in (total)	-
A + B: C - D:	0°24' +-12' (0.40° + 0.20°) 4 +- 2 mm (0.16 +- 0.08 in.)

HINT:

Measure "C - D" only when "A + B" cannot be measured.
If toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.

Fig 1: Identifying Toe-In
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

ADJUST TOE-IN
1. Measure the lengths of the right and left No. 2 suspension arms.
  No. 2 suspension arm length difference: 1.5 mm (0.06 in.) or less
  
  If the left-right difference is larger than 1.5 mm (0.06 in.), adjust it by following the procedures below.
  
  Fig 2: Measuring Lengths Of Right And Left No. 2 Suspension Arms
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Loosen the 2 lock nuts.
3. Turn the right and left adjusting tubes by an equal amount to adjust toe-in.
  HINT:
  - Try to adjust toe-in to the center value.
  - One turn of each adjusting tube will adjust toe-in by approximately 1.2° (1°12'), 10.8 mm (0.425 in.).
4. Torque the 2 lock nuts.
  Torque: 56 N*m (570 kgf*cm, 41 ft.*lbf)
  
  Fig 3: Turning Right And Left Adjusting Tubes
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSPECT CAMBER

CAMBER SPECIFICATION

-	XL	TOURING
Camber Right-left error	-1°09'+- 45' (-1.15° +-0.75°) 45' (0.75°) or less	-1°13' +- 45' (-1.22° +- 0.75°) 45' (0.75°) or less
	XLS	LIMITED
	-1°13' +- 45' (-1.22° +- 0.75°) 45' (0.75°) or less	-1°15' +- 45' (-1.25° +- 0.75°) 45' (0.75°) or less

HINT:

Camber is not adjustable. If the measurement is not within the specification, inspect the suspension parts for damage and/or wear, and replace them if necessary.