BRAKE ACTUATOR (w/o VSC): Installation

INSTALL BRAKE ACTUATOR WITH BRACKET
1. Install the brake actuator with bracket with the 3 bolts.
  Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
  
  NOTE: Do not damage the brake tubes and wire harness.
  
  Fig 1: Locating Brake Actuator With Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, connect each brake line to the correct position of the brake actuator as shown in the illustration.
  Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)
3. Connect the brake actuator connector.
FILL RESERVOIR WITH BRAKE FLUID (See BLEEDING )
BLEED MASTER CYLINDER (See BLEEDING )
BLEED BRAKE LINE (See BLEEDING )
CHECK BRAKE FLUID LEAKAGE
CHECK FLUID LEVEL IN RESERVOIR (See BLEEDING )

Fig 2: Identifying Tags For Reconnection Points
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
CHECK BRAKE ACTUATOR WITH TECHSTREAM
1. Check the brake actuator (See ON-VEHICLE INSPECTION ).