Fuel Pump Relay: Inspection

WARNING: This page is about a different variant/trim than selected.

INSPECT FUEL PUMP RELAY ASSEMBLY

Check the resistance.

Using an ohmmeter, measure the resistance between the terminals.

Resistance

RESISTANCE SPECIFICATION TABLE

Tester Connection	Specified Condition
3 - 4	Below 1 Ω
3 - 5	10 kΩ or higher
3 - 4	10 kΩ or higher (Apply battery voltage to terminals 1 and 2)
3 - 5	Below 1 Ω (Apply battery voltage to terminals 1 and 2)

If the result is not as specified, replace the fuel pump relay.

Fig 1: Measuring Resistance Between Fuel Pump Relay Terminals