Combination Meter Buzzer Circuit Inspection

WARNING: This page is about a different car, the 2007 Nissan Versa. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CHIME OPERATION
1. Select "BUZZER" of "BCM" on CONSULT-II.
2. Perform "LIGHT WARN ALM" or "IGN KEY WARN ALM" of "ACTIVE TEST".
Does chime sound?

YES >> Combination meter buzzer circuit is OK. Return to "SYMPTOM CHART ".

NO >> GO TO 2.

Fig 1: CONSULT-II Display - Active Test
CHECK COMBINATION METER INPUT SIGNAL
1. Select "METER" on CONSULT-II.
2. Turn on hazard switch or lighting switch while monitoring "BUZZER" of "DATA MONITOR" and check operation status.
  "BUZZER"
  
  While hazard switch or lighting switch is ON: ON and OFF repeatedly
  
  Except above: OFF
OK or NG

OK >> Check battery power supply circuit of combination meter. If OK, replace combination meter. Refer to " COMBINATION METER " .

NG >> Replace BCM. Refer to " REMOVAL AND INSTALLATION OF BCM " .

Fig 2: CONSULT-II Display - Data Monitor