Throttle Body: Installation

INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY
1. Install a new gasket and the throttle body with motor with the 4 bolts.
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
2. Connect the throttle position sensor and throttle control motor connector.
  
  Fig 1: Identifying Throttle Position Sensor And Throttle Control Motor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the No. 4 water by-pass hose.
  
  Fig 2: Locating Water By-Pass Hose No. 4
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the No. 5 water by-pass hose.
  
  Fig 3: Locating Water By-Pass Hose No. 5
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER ASSEMBLY WITH ELEMENT (See INSTALLATION )
INSTALL NO. 2 AIR CLEANER HOSE (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
ADD ENGINE COOLANT (See REPLACEMENT )
INSPECT FOR ENGINE COOLANT LEAK (See ON-VEHICLE INSPECTION )
INSTALL V-BANK COVER (See INSTALLATION )
INSTALL FRONT COWL TOP OUTER PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY
1. Install the front wiper motor and link assembly (see INSTALLATION ).
INSTALL NO. 1 ENGINE UNDER COVER (See INSTALLATION )