LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Tundra Base, 4.0 U >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (1GR-FE) - System Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Knock Sensor >> Removal

Knock Sensor: Removal

  1. REMOVE ENGINE ASSEMBLY 
    1. Remove the engine (see REMOVAL ).
  2. REMOVE CYLINDER HEAD SUB-ASSEMBLY RH (for Bank 1) 
    1. Remove the cylinder head RH (see REMOVAL ).
  3. REMOVE NO. 1 WATER OUTLET PIPE 
    1. Remove the 4 wire harness clamps [A].
    2. Remove the 3 bolts [B] and water outlet pipe.
      Fig 1: Locating Water Outlet Pipe Bolts
      G04968676Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE KNOCK SENSOR 
    1. Disconnect the 2 sensor connectors.
    2. Remove the 2 bolts and 2 sensors.
      Fig 2: Locating Knock Sensor Bolts
      G05149610Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals