LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Tundra Base, 4.0 U >> Repair and Diagnosis >> Body & Frame >> Windows >> Windshield/Window Glass >> Power Window Control System >> Data List / Active Test

Data List / Active Test

  1. READ DATA LIST 

    HINT:

    Using the intelligent tester or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Warm up the engine.
    2. Turn the ignition switch OFF.
    3. Connect the intelligent tester or Techstream to the DLC3.
    4. Turn the ignition switch ON.
    5. Turn the tester on.
    6. Enter the following menus:
      1. Intelligent tester - Select: DIAGNOSIS / OBD/ MOBD / MAIN BODY / DATA LIST / ALL.
      2. Techstream - Select: Body Electrical / Main Body / Data List.
    7. According to the display on tester, read the "DATA LIST" or "Data List".
      1. Intelligent tester

        MAIN BODY: 

        MAIN BODY - INTELLIGENT TESTER DISPLAY REFERENCE CHART

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        D DOR CTY SW Driver side door courtesy switch signal /ON or OFF ON: Driver door open
        OFF: Driver door closed        		 -
        P DOR CTY SW Front passenger side door courtesy switch signal / ON or OFF ON: Front passenger door open
        OFF: Front passenger door closed        		 -
      2. Techstream

        Main Body: 

        MAIN BODY - TECHSTREAM TESTER DISPLAY REFERENCE CHART

        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        D Door Courtesy SW Driver side door courtesy switch signal / ON or OFF ON: Driver door open
        OFF: Driver door closed        		 -
        P Door Courtesy SW Front passenger side door courtesy switch signal / ON or OFF ON: Front passenger door open
        OFF: Front passenger door closed        		 -
  2. PERFORM ACTIVE TEST 

    HINT:

    Using the intelligent tester or Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Warm up the engine.
    2. Turn the ignition switch OFF.
    3. Connect the intelligent tester or Techstream to the DLC3.
    4. Turn the ignition switch ON.
    5. Turn the tester on.
    6. Enter the following menus:
      1. Intelligent tester - Select: DIAGNOSIS / OBD/ MOBD / MAIN BODY / ACTIVE TEST.
      2. Techstream - Select: Body Electrical / Main Body / Active Test.
    7. According to the display on tester, perform the "ACTIVE TEST" or "Active Test".
      1. Intelligent tester

        MAIN BODY: 

        MAIN BODY - INTELLIGENT TESTER DISPLAY REFERENCE CHART

        Tester Display Test Part Control Range Diagnostic Note
        IG OFF P/W Power window control permission output ON or OFF -
      2. Techstream

        Main Body: 

        MAIN BODY - TECHSTREAM TESTER DISPLAY REFERENCE CHART

        Tester Display Test Part Control Range Diagnostic Note
        IG OFF P/W Control Permission Output Power window control permission output ON or OFF -
scientia non olet · About LEMON Manuals