LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Tacoma X-Runner >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Axle >> Front Axle Hub Bolt >> Installation

Front Axle Hub Bolt: Installation

  1. INSTALL FRONT AXLE HUB BOLT 
    1. Install a new hub bolt through the axle hub.
    2. Install the washer plate, as shown in Fig 1, through the hub bolt, and install the hub bolt by tightening the hub nut.
  2. INSTALL FRONT DISC 
  3. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY (for 2WD) (See  INSTALLATION  ) 
  4. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY (for 4WD and Pre-Runner) (See  INSTALLATION  ) 
  5. INSTALL FRONT WHEEL 

    Torque: 113 N*m (1,152 kgf*cm, 83 ft.*lbf) 

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

    (See REPAIR INSTRUCTION )

  7. FILL RESERVOIR WITH BRAKE FLUID (w / VSC) (See  BRAKE FLUID (W / VSC)  ) 
  8. FILL RESERVOIR WITH BRAKE FLUID (w/o VSC) (See  BRAKE FLUID (W/O VSC)  ) 
  9. BLEED MASTER CYLINDER (w/o VSC) (See  BRAKE FLUID (W/O VSC)  ) 
  10. BLEED BRAKE LINE (w / VSC) (See  BRAKE FLUID (W / VSC)  ) 
  11. BLEED BRAKE LINE (w/o VSC) (See  BRAKE FLUID (W/O VSC)  ) 
  12. CHECK FLUID LEVEL IN RESERVOIR (w / VSC) (See  BRAKE FLUID (W / VSC)  ) 
  13. CHECK FLUID LEVEL IN RESERVOIR (w/o VSC) (See  BRAKE FLUID (W/O VSC)  ) 
  14. CHECK FOR BRAKE FLUID LEAKAGE 
Fig 1: Installing New Hub Bolt Through Axle Hub
G04369798Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals