Crankshaft Position Sensor: Installation

1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
   Fig 1: Applying Light Coat Of Engine Oil To O-Ring Of Crankshaft Position Sensor

   Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. Install the camshaft position sensor with the bolt.

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

   NOTE: Make sure that the O-ring is not cracked or jammed when installing.
   Fig 2: Installing Camshaft Position Sensor With Bolt

   Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3. Connect the crankshaft position sensor connector and the 2 wire harness clamps.
   Fig 3: Connecting Crankshaft Position Sensor Connector And Wire Harness Clamps

   Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

1. Using several steps, uniformly install and tighten the 5 bolts in the sequence shown in the illustration.

   Torque: 21 N*m (214 kgf*cm, 16 ft.*lbf) for bolt A 

   43 N*m (438 kgf*cm, 32 ft.*lbf) for bolt B, C 

Fig 4: Identifying Sequence Of Tightening Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.

Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)