LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Tacoma PreRunner, 2D Pickup >> Repair and Diagnosis >> Engine Performance >> Engine Control System (2TR-FE) >> Accelerator Pedal >> On-Vehicle Inspection

On-Vehicle Inspection

  1. INSPECT ACCELERATOR PEDAL ASSEMBLY 
    1. Inspect the voltage.
      1. Connect the intelligent tester to the DLC3.
        2. Fig 1: Connecting Intelligent Tester (With CAN VIM) To DLC3
        G05198635Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
      2. Turn the ignition switch to ON.
      3. Turn the intelligent tester ON.
      4. Select the following menu items: DIAGNOSIS / ENHANCED OBD II / DATA LIST /ALL /ACCEL POS#1, ACCEL POS#2.
      5. Operate the accelerator pedal, then check that the ACCEL POS #1 and ACCEL POS #2 values are within the specified ranges.

        ACCEL POS #1 

        ACCELERATOR PEDAL CONDITION

        Accelerator Pedal Condition Specified Condition
        Released 0.5 to 1.1V
        Depressed 2.6 to 4.5 V

        ACCEL POS #2 

        ACCELERATOR PEDAL CONDITION AND SPECIFIED CONDITION

        Accelerator Pedal Condition Specified Condition
        Released 1.2 to 2.0 V
        Depressed 3.4 to 5.0 V

        If the result is not as specified, check the accelerator pedal, wire harness and ECM.

scientia non olet · About LEMON Manuals