Circuit Opening Relay: Inspection
WARNING: This page is about a different variant/trim than selected.
- INSPECT CIRCUIT OPENING RELAY ASSEMBLY
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Standard
STANDARD REFERENCE CHART
| Tester Connection |
Specified Condition |
| 3 - 5 |
10 kΩ or higher |
| 3 - 5 |
Below 1 Ω (Apply battery voltage to terminals 1 and 2) |
If the result is not as specified, replace the circuit opening relay assembly.
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.