LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Tacoma Base, 4D Pickup, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System (2TR-FE)) >> Camshaft Position Sensor >> Removal

Camshaft Position Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE CAMSHAFT POSITION SENSOR 
    1. Disconnect the camshaft position sensor connector.
    2. Remove the bolt, then remove the camshaft position sensor.
      Fig 1: Installing Camshaft Position Sensor With Bolt
      G05198393Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
scientia non olet · About LEMON Manuals