LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Sienna LE, AWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Engine Fuel System >> Fuel Pressure Pulsation Damper >> Removal

Fuel Pressure Pulsation Damper: Removal

  1. DISCHARGE FUEL SYSTEM PRESSURE 

    HINT:

    See PRECAUTION  .

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  3. REMOVE NO. 1 ENGINE UNDER COVER 
  4. DRAIN ENGINE COOLANT  (See REPLACEMENT )
  5. REMOVE FRONT WIPER ARM HEAD CAP  (See REMOVAL )
  6. REMOVE FRONT WIPER ARM RH  (See REMOVAL )
  7. REMOVE FRONT WIPER ARM LH  (See REMOVAL )
  8. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  9. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See REMOVAL )
  10. REMOVE NO. 1 COWL TOP TO COWL BRACE INNER  (See REMOVAL  )
  11. REMOVE COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT  (See REMOVAL  )
  12. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  13. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL  )
  14. REMOVE INTAKE AIR SURGE TANK ASSEMBLY  (See REMOVAL  )
  15. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY 
    1. Remove the clip.
    2. Pull out the fuel pressure pulsation damper from the fuel delivery pipe.
    3. Remove the O-ring from the fuel pressure pulsation damper.
      Fig 1: Identifying Pulsation Damper And O-Ring
      G05138210Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals