Back Door Glass: Removal

REMOVE BACK DOOR GARNISH CENTER
REMOVE BACK DOOR SIDE GARNISH LH
REMOVE BACK DOOR SIDE GARNISH RH
REMOVE BACK DOOR STRAP COVER
REMOVE BACK DOOR PULL STRAP
REMOVE BACK DOOR TRIM BOARD ASSEMBLY
REMOVE BACK DOOR SERVICE HOLE PLATE
REMOVE REAR SPOILER COVER (W/ REAR SPOILER)
REMOVE FRONT WIPER ARM HEAD CAP
REMOVE REAR WIPER ARM
REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY
REMOVE BACK DOOR GLASS
1. Pass a piano wire between the body and glass from the interior.
  
  Fig 1: Passing Piano Wire Between Body And Glass
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Tie both wire ends to wooden blocks or similar objects.
  HINT:
  
  Apply protective tape to the outer surface to prevent the surface from being scratched.
  
  NOTE: When separating the glass, take care not to damage the paint and interior and exterior ornaments.
  
  Fig 2: Identifying Protective Tape To Outer Surface Of Glass
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Cut off the adhesive by pulling piano wire around it.
4. Using a suction rubber, remove the glass.
  NOTE: Leave as much adhesive on the body as possible when removing the glass.
CLEAN BACK DOOR GLASS
1. Clean the outer circumference of the glass white gasoline.
  NOTE:
  - Do not touch the glass surface after cleaning it.
  - Be careful not to damage the body.
    
    Fig 3: Cleaning Outer Circumference Of Glass
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002