Charging System: Generator: Installation

1. Install the generator with the bolt and the 2 nuts.

   Torque: Bolt 39 N*m (400 kgf*cm, 29 ft.*lbf) 

   Nut 10 mm 39 N*m (400 kgf*cm, 29 ft.*lbf) 

   Nut 8 mm 15.5 N*m (158 kgf*cm, 11 ft.*lbf) 

2. Connect the generator connector.
3. Connect the generator wire with the nut.

   Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

4. Install the terminal cap.
5. Install the wire clamp to the cord clip on the generator.

(See INSTALLATION )

1. Install the belt by turning the belt tensioner counterclockwise.
   NOTE: The pulley bolt for the belt tensioner has a left - hand thread. 
   Fig 1: Installing Belt By Turning Belt Tensioner Counterclockwise

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

(See ON-VEHICLE INSPECTION  )

1. Perform initialization. (See INITIALIZATION )

   HINT:

   Some system need initialization when disconnecting the cable from the battery terminal.