Inspection Procedure

HINT:

When using the intelligent tester, start the inspection from step 1 and when not using the intelligent tester, start from step  2.

1. READ VALUE OF INTELLIGENT TESTER (LIMIT SWITCH) 
   1. Connect the intelligent tester to the DLC3.
   2. Turn the ignition switch ON.
   3. According to the display on the tester, read the DATA LIST.

      P-DOOR 

      P-DOOR DATA LIST REFERENCE
      
      

      Item	Measurement Item/Display (Range)	Normal condition	Diagnostic Note
      LIMIT SW	Jam protection limit SW/ON or OFF	ON: Window is almost fully open OFF: Window is open	(1)
      (1) If the jam protection limit switch is turned ON, the jam protection function will stop.

      Even if the switch is not turned ON when the windows are almost fully open, the window will not fully close as jam protection operates at upper window positions during automatic-up operation.

   OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

   NG: GO TO NEXT STEP 

2. INSPECT JAM PROTECTION LIMIT SWITCH (JAM PROTECTION FUNCTION) 

   NG: REPLACE FRONT PASSENGER SIDE POWER WINDOW MOTOR 

   OK: GO TO NEXT STEP 

3. CHECK HARNESS AND CONNECTOR (JAM PROTECTION LIMIT SWITCH - PASSENGER DOOR ECU) 

   NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

   OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE